Clip for Strips LoRaWAN
+Clip is an accessory designed for mounting Strips sensors close to a surface to enable reliable measurement of moisture and environmental changes over time.
It is particularly useful in applications where direct adhesive mounting is not suitable or where flexible installation is required.
+Clip is compatible with all Strips sensors except Strips Drip.
Typical use cases
Installation on rough surfaces such as concrete, brick, or untreated wood
Temporary or repositionable sensor installations
Applications requiring flexible or non-permanent mounting
Key advantages
Enables close contact with surfaces for accurate measurements
Suitable for rough or uneven materials where adhesive mounting is not reliable
Allows easy installation and removal of sensors
Supports flexible and reusable deployments
Cost-efficient mounting solution
Installation
+Clip is used together with Strips sensors to secure the device against a surface without relying on the built-in adhesive.
One or two clips can be used per sensor depending on mounting requirements and surface conditions.
This enables both permanent and temporary mounting depending on application needs.
Rev B, 2026-03-18
| Application | |
|---|---|
| Application | Relative moisture in materials |
| Benefits | |
| Benefits | Mount on dirty surfaces where adhesive won't stick, Mount and re-mount sensor many times, Tight mounting to measure surface moisture and relative humidity |
| Connectivity data | |
| Protocols / Connectivity | NA |
| Mechanical data | |
| Width (mm) | 20 |
| Depth (mm) | 29 |
| Height (mm) | 4 |
| Internal | |
| Manufacturer | Sensative |